Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.
|Published (Last):||1 April 2014|
|PDF File Size:||11.71 Mb|
|ePub File Size:||15.34 Mb|
|Price:||Free* [*Free Regsitration Required]|
A number in parentheses indicates the year of last reapproval. Historical Version s – view previous versions of standard.
ASTM A493 Grade 384 annealed
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Last previous edition A — Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. NOTE 1—A typical ordering description is as follows: The material shall also conform to the requirements as to mechanical properties. Soap is x493 used.
Such requirements may include, but are not limited to the following: Originally published as A — The following coatings may be specied: This specification covers cold-finished and s493 stainless steel wire and wire rods for cold heading or cold forging for applications, such as fasteners, where corrosion resistance is a factor.
The producer should be consulted when material is required to tensile strength ranges aatm than those specied. For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades.
General Requirements for Delivery 4. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Packaging and Package Marking 9.
ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging
An electroplated copper coating is often used. The following lubricants may be specied: The steel shall conform to the required chemical composition requirements.
Z493 values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Link to Active This link will always route to the current A439 version of the standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0. This standard is subject to revision at any time by the axtm technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn.
ICS Number Code Material can be manufactured to tensile strength ranges other than those shown in Table 2. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. A superscript epsilon e indicates an editorial change since the last revision or ast. The SI equivalents are in parentheses and may be approximate.
Resistance to Intergranular Corrosion 8. All austenitic grades in the annealed condition or annealed and lightly drafted condition shall be capable of passing the criteria set by this specification. This standard has been approved for use by agencies of astn Department of Defense.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Current edition approved Jan. Copyright ASTM Standard Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.