This revision permits the publication of BS EN to be adopted as a Harmonised Standard under the Constuction Products Directive. BS EN. Hot finished structural hollow sections of non-alloy and fine grain steels -. Part 1: Technical delivery conditions d Copy. Find the most up-to-date version of BS EN at Engineering
|Published (Last):||5 September 2011|
|PDF File Size:||19.66 Mb|
|ePub File Size:||9.46 Mb|
|Price:||Free* [*Free Regsitration Required]|
Impact tests shall be carried out at the temperatures specified in Table A.
SJ2H structural hollow section according to EN – SSAB
For dated references, only the edition cited applies. The qualification shall be in accordance with EN or, at least, an equivalent to it. Other requirements and other EU Directives, not affecting the fitness for intended use may be applicable to a construction product falling within the scope of this standard.
To consider the test unit as conforming after testing the second set, the following conditions shall all be satisfied simultaneously: Contact the Information Centre. A version in any other language made by translation under the responsibility of a CEN member into its own hs and notified to the Central Secretariat has the same status as the official versions.
Steel hollow sections To be used in metal structures or in composite metal and concrete structures Requirement clauses in this European Standard EN In addition, initial type testing shall be performed: Longitudinal or transverse samples at the discretion of the manufacturer.
Carbon and low alloy steels ISO Ne arc welded sections 9. The declaration shall be accompanied by a factory production control system certificate, drawn up by a notified body, which shall contain in addition to the information above, the following? The operating authorisation issued by the employer shall be in accordance with a written procedure.
If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained.
Design of steel structures – Part In the event that the purchaser does not indicate a wish to implement any of these options at the time of enquiry and order, the hollow sections shall be supplied in accordance with the basic specification. The attestation of conformity of the steel hollow sections in Table ZA. The Amber document status indicator indicates that some caution is needed when using this document – it is either: During ba design process itself, a record shall be kept of all checks, their results, and any corrective actions taken.
Take the smart route to manage medical device compliance. Table 4 — Test units Licensed Copy: The following performance characteristics are not subject to initial type testing for the following reasons: We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover.
If the nominal product thickness is not sufficient for the preparation of standard test pieces, the test shall be 100210-1 out using test pieces of width less than 10 mm, but not less than 5 mm. Find Similar Items This product falls into the following categories.
Hollow section for general applications
The purchaser should preferably select hollow section dimensions from this limited range of sizes. This ne is best viewed with browser version of up to Microsoft Internet Explorer 8 or Firefox 3. Conditions techniques de livraison.
Tensile strength and yield strength 6.
BS EN for Hot Finished Structural Hollow Sections
For undated references, the latest edition of the referenced document including any amendments applies. Click here to find out how to access 10210- document. Method of test at ambient temperature EN Structural hollow sections of fine grain steels shall conform to the requirements of Annex B.
This record shall be sufficiently detailed and accurate to demonstrate that all stages of bz design phase, and all checks, have been carried out satisfactorily. Test method EN In these cases, verification of the grain size is not required. Supersedes BS EN Steel names ENDesignation systems for steels – Part 2: The choice of a suitable physical or chemical analytical method for the analysis shall be at the discretion of the manufacturer.